Read this manual carefully and thoroughly to prevent and injury or damage. We recommend that you become comfortable with the smoke generator and all of its functions before use.

1. Cut the insulation out of the hole for the smoke generator hookup.

2. Using a 3" hole saw, drill a hole in the center of the smoke generator hookup from the inside.
    a. Should be centered at 13" from front and 16" up from bottom of the smokehouse
    b. Only drill the leader hole, do not cut the 3" hole.

3. Using that hole as a guide, cut the 3" hole in the side of the smokehouse for the smoke generator from the outside.

4. Line up the smoke generator inlet in the 3" hole so that the weld is facing down, mark and drill pilot holes then secure with self-tapping screws or rivets.
    a. If you did not purchase the smoke generator inlet from The Sausage Maker, you can use Galvanized 3" flue or duct piping

5. Attach the smoke generator by inserting the tubing on the side of the smoke generator into the smoke generator inlet.

6. Remove only the wing nuts and lock washers from the blower plate assembly.
    a. The two remaining nuts should be on the top right and lower left when you are facing the blower hole.

7. Line up the two remaining nuts and two bolts with the holes on the side of the smoke generator and reattach the wing nuts and lock washers.